How i can configure the server client network ?

Question

Hi Everybody , I Have 50 sys in my company , we are going to make a server client system ,i have static ip .how i can configure the network ?i want share the internet connection . how i want configure server side and client side?

Answer 1

you have not mentioned which operating system you are using.assuming that you are using microsoft plateform

1)if wanted client authentication in your network.then first install active directory(and dns) on server.

2)configure dhcp server

3)if this same server you want to use for internet connection.then you need two network card installed

4)now provide static ip address to one interface assigned by isp.now enable nat/pat on that interface

5)enable routing services on the server.configure static route.

you can follow this architecture.but if you have routers then you need not configure routing services and nat/pat on server.

for this connect one interface of server to router(may not be directly).enable pat on router interface facing isp.configure provider facing roter interface with static ip address.configure static route on router.in dhcp scope mention router interface(inside) ip address as default gateway

this is only a guideline.but you have to configure everything

Answer 2

Client IP Address Save into Sever system

Drivers/etc/host/notepad

Add every system IP addresses

and connect all systems into any one connector or hubs

Answer 3

you are able to provide your received ip addresses on your NIC2 for instance in case you prefer to furnish classification c address 192.168.a million.a million 255.255.255.0 supply it as your NIc2 ip address it is the default gateway very last addresses you are able to provide it on your community. that advise from 192.168.0.2 to 192.168.0.253 on your clints word supply the nic2 address because the default gateway