Do I need to replace my 100BaseT cabling with 1000BaseT cabline if I am updgrading my wireless router to GB?

Question

I have a typical home wireless router with built in 4 port switch. I have two PCs plugged into the router and the router is plugged into a cable modem. All of the cabling used is 100BaseT. I plan on upgrading the router with a 1000BaseT (Gigabit) router to speed up file sharing between the two PCs. The NIC cards on the two PCs already support 1000BaseT. After putting the new Gigabit router in place, will I have to replace the cabling as well in order to get a full 1000 gbps on the local network?

Answer 1

If your cables are CAT5E , they will handle Gigabyte up to quite reasonable distances. Not as far on CAT5E as CAT6. CAT5 will do so but to shorter distances again. I have changed to Gigabyte in a few smaller offices without re-cabling from 5E.

Answer 2

you need to connect the on the spot router on your abode community. this could encompass your laptop(s), your cable modem, and could in all hazard additionally fucntion because of the fact the gadget that hyperlinks them. The router won't replace the modem. The wirless router takes wirless records from the 'air' and gets it into the 'under pressure' community. It then 'routes' (subsequently that catchy 'router' call) the records the place it needs to bypass... no rely if this is on your printer (this is linked to the community), yet another laptop, or the internetz. The modem needs to chat alongside with your cable corporation as a fashion to get the sign into something your laptop can use. you will ought to have the modem. on a similar time as on the spot technologies is somewhat in the back of under pressure to this point as velocity is in contact, once you're paying for a sparkling (and not used or previous) sort then you certainly likely won't observe a difference except you get a number of (like 5+) on the spot computers working downloads on the comparable time. the ingredient to bear in mind approximately velocity is that your cyber web connection (except you reside able that has fiber) is AT maximum approximately 5 meg according to 2nd. New on the spot routers perform at approximately fifty 4 meg according to 2nd, and your stable previous blue/green community cable is going at a hundred (even 1000 in some extra moderen computers) meg according to 2nd. In different words in the experience that your connection is sluggish this is likely your cyber web, not something with you. As to the PSP question, i've got in no way configured a router for a gaming gadget, yet on the spot networking is on the spot networking. Sony could be stupid to make a gadget that throughout ordinary terms works off of a particular 'form' of on the spot. i assume you would be fantastic, nonetheless they could have a commonly used sort (for setup motives) i could merely examine the internet and notice on that one.

Answer 3

Possibly.



In order to attain 1000BT your cabling must conform to the writing specification as indicated here: http://en.wikipedia.org/wiki/Cat5e



Your cable must be wired to the T568B or T568A spec indicated by the graphics on that page.



While there are other factors that can dictate performance the wiring spec is the most crucial. So it's safe to say that if your wires conform to the indicated spec, then you should be OK. However, this is no guarantee as 1000BT is less tolerant of problems and will degrade quickly or fail all together; 100BT on the other hand is very tolerant.



The wiki page should guide you further.

Answer 4

If you have at least CAT 5e cables, then you are set. Anything lower does not support gigabit ethernet.

Answer 5

You'll be good for 100 feet or so with your 5e STP cable.

If you need to go out to the barn, replace that run with cat6.

Answer 6

What Is 100baset